Epson L-6034VW Operation Guide FAQ When using white gradation, you cannot print correctly on parts that overlap with color sections. A. For parts that overlap with color sections, create print data with 100% white for the white plate you set. When using gradation for the white plate with surface white printing or reverse white printing, you may not be able to print parts that overlap with color images correctly. This occurs because the ink flow and dot contact points occur due to ink unevenness when printing on the base, and the amount of ink on the printed surface becomes uneven.
When white gradation and colored images overlap (the leaf in the following illustration), by setting the parts that overlap to 100% white you can prevent unevenness in the amount of ink and print correctly. Gradation for the white plate is displayed in yellow in the following illustration. Eye mark pitch (interval) when printing on single-ply films A. Single-ply films have the characteristics of stretching or contracting. Therefore, when using eye marks, the pitch (interval) between eye marks may expand or contract, which could misalign the print position or generate an error, and you may not be able to print correctly. See the following to change the pitch of the eye marks.
Eye Mark for Reverse Feeding Change the page length of the print data depending on the substrate width. The page length of the print data is used as the eye mark pitch for reverse feeding. Eye mark for additional printing Change the pitch of the eye mark arrangement for base printing according to the substrate width. Also, make sure you set the value for the changed eye mark pitch in the Eye Mark Pitch for print information. U “Details of Print Info. Setting Content (Print Info. Editing Screen)” on page 109 236 Substrate width Minimum page length for print data 120 mm or more 30 mm Less than 120 mm 60 mm