Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-6 E URO C ARGO E URO 4 - 5 Dimensions and masses - The anti-noise panels must not be altered or moved in order to prevent changes in the approved noise levels of the vehicle. Should it be necessary to make openings (e.g. for the longitudinal runner of the body to pass through) these must be properly closed off using material with inflammability and soundproofing characteristics equivalent to those used originally. - Adequate brake ventilation and battery box airing must be ensured.

- When positioning the mud flaps and wheelhouses, sufficient space must be left for free rebound of the rear wheels even when used with chains; sufficient space must also be left for the tyres of any additional liftable axles. - When vehicle body building has been completed the adjustment of the headlights must be checked for safety and re-adjusted where necessary. - In the case of parts which are supplied loose (e.g. spare wheel, chocks) it will be the responsibility of the bodybuilder to position and secure them in an accessible and safe manner in compliance with relevant national and international regulations.

3.2 Dimensions and weights 3.2.1 General Specifications The dimensions and maximum permissible load on the axles are indicated on drawings, on technical specifications and, in greater details, on the official documentation issued by the Company. The kerb weights refer to vehicles with standard equipment. Special equipment may involve considerable modification to the weight and its distribution on the axles. On our models, positioning of the lights and rear view mirrors is designed for widths of up to 2600 mm (see point 2.27). Weighing the Chassis A tolerance of ± 3% should be allowed for on published weights.

It is, therefore, necessary to determine the weight of the vehicle with its cab before fitting the body and equipment and establishing the distribution on the axles. 3.2.2 Determining the Centre of Gravity of the Body and Payload Centre of Gravity: Positioning on longitudinal plane To establish the location of the centre of gravity of the body and payload the following examples below may be used as guidelines. The technical documentation specific to each model (chassis cab drawing) give the positions permitted with the vehicle in its standard form. Base - July 2006 Revi - June 2007 Print 603.93.431