Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-14 E URO C ARGO E URO 4 - 5 Aluminium Subframe In the case of materials, having different characteristics compared to steel, such as aluminium, both the dimensions and the structures of the subframe will have, as a rule, to be adapted accordingly. When the subframe’s main function is mainly to distribute the load more evenly while leaving the major load-bearing to the frame, aluminium longitudinal runners can be used having the same dimensions as stated for the steel. Some typical examples are: fixed bodies, vans, tanks with continuous and close spaced bearers or bearers mounted directly over the suspension hanger brackets.

Exceptions are those cases where the high stresses on the vehicle’s frame demand steel runners of a high dimension or shear-resistant connections. When the subframe must contribute in terms of strength and stiffness (bodies having high concentrated loads, such as tippers, cranes, central axle trailers, etc.) aluminium is not recommended and has therefore to be authorised for each application. It should be remembered that, when stating the minimum dimensions for the reinforcement runners, besides the admitted limit of stress for the aluminium, the different elastic modulus compared to steel (approx. 7,000 kg/mm 2 as against 21,000 kg/mm 2 for steel) will also have to be considered.

This will result in larger dimensions for the runners. 3.3.2 Section bar dimensions The table below specifies the values for the section modulus W x for C-section longitudinal runners recommended by IVECO. The indicated W x value refers to the real section and allows for the section radii (it can be calculated with some approximation by multiplying by 0.95 the value obtained by considering the section made up of simple rectangles). Longitudinals of different sections can be used as replacements for the indicated ones, provided that the section modulus W x and the moment of inertia J x of the new C-section is not lower than those shown in the table.

Base - July 2006 Revi - June 2007 Print 603.93.431