Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

Print 603.93.431 Base - July 2006 Revi - June 2007 EUROCARGO EURO 4 - 5 FITTING SUPER STRUCTURES 3-13 Construction of the Subframe 3.3 Construction of the Subframe The purpose of a subframe (auxiliary frame) is to ensure a uniform distribution of the load on the vehicle’s chassis and to increase the strength and rigidity of the main frame in relation to the particular use of the vehicle. The following points are to be borne in mind when constructing a subframe: 3.3.1 Material Usually, provided the subframe is not to undergo great stress, the material used for its construction may be of a lower grade than that used for the vehicle chassis.

It must have good welding characteristics and limits not lower than those of the following material: Table 3.1 - Material to be used for body manufacturing Steel name Tensile strength (N/mm2) Yield point (N/mm2) Elongation A5 IVECO Fe360D 360 235 25% Europe S235J2G3 Germany St37-3N UK 40D Should the stress limits require it (e.g. if cranes or tail lifts are to be fitted), or if very high sections are to be avoided, material with better mechanical characteristics may be used. In this case it should be considered that a lower inertia moment of the reinforcing beam implies high bending stresses on the chassis frame. The properties of materials shown in later applications are as follows.

Table 3.2 - Material to be used for body manufacturing Steel name Tensile strength (N/mm2) Yield point (N/mm2) Elongation A5 IVECO FeE420 530 420 21% Europe S420MC Germany QStE420TM UK 50F45 Table 3.3 - Material to be used for body manufacturing Steel name Tensile strength (N/mm2) Yield point (N/mm2) Elongation A5 IVECO Fe510D 520 360 22% Europe S355J2G3 Germany St52-3N UK 50D