FITTING SUPER STRUCTURES 3-12 E URO C ARGO E URO 4 - 5 In versions where the payload tends to move on side (e.g. suspended loads, fluid loads etc.) especially when turning, higher dynamic stress is generated which makes the vehicle less stable. This must be taken into consideration when providingvehicle operatinginstructions orfor possible reduction in the height of the centre of gravity. 3.2.4 Using stabiliser bars Supplementary stabilising or anti-roll bars, where available, spring reinforcements or the application of rubber components (in compliance with point 2.12), may increase the height of the centre of gravity of the payload which must be defined as each occasion arises.
The modification must be carried out after careful consideration has been given to the specifications of the model, to the wheelbase and to the distribution of the cross-stresses acting on the suspension both at the front and at the rear of the vehicle. It must be borne in mind that it is often advisable to modify the rear axle only since a modified front axle would give the driver a false sense of stability making it more difficult to perceive the safety limits. Modification to the front axle may be made where the load is positioned behind the cab (e.g. crane) or where the superstructures are very rigid (e.g. van conversion). In the case of special loads with high centre of gravity (e.g.
machinery, indivisible loads, etc.), it is technically possible to exceed the limit values of height of centre of gravity, provided that the style of driving of the vehicle is suitably adapted (e.g. reduced speed, gradual steering, etc.). Base - July 2006 Revi - June 2007 Print 603.93.431