FITTING SUPER STRUCTURES 3-11 E URO C ARGO E URO 4 - 5 3.2.3 Observing the Permitted Weights All the limits indicated in IVECO documents must be complied with; the load on the front axle is particularly important, under all loading conditions, in order to ensure the necessary steering and braking characteristics in all road conditions. The approved minimum kerb weights in accordance with EC Directive 98/12 must be adhered to for the complete vehicle and its distribution over the axles. Particularattention must therefore be paid to vehicleswith a weight which isconcentrated on the rearoverhang (e.g.
cranes, tail-lifts, centre axle trailers) and to vehicles with a short wheelbase and a high centre of gravity (e.g. bulk tankers, cement mixers). When positioning the body and equipment, the loads must be correctly distributed transversally. For each wheel a variation in the rated load (1/2 the load on the axle) of 4% is permitted (e.g. admitted load on axle: 10,000 kg load admitted on each wheel: 4,800 to 5,200 kg) provided the tyres permit it, without impairing braking or driving stability. For vehicles with an added rear lift axle it must be remembered that, with the axle in the raised position, the effective wheelbase is reduced, whereas the rear overhang is increased.
It is therefore advisable that the centre of gravity of the body and payload is located in front of the centre line of the driving axle. In addition to this it is not advisable to equip a vehicle which has its load concentrated at the rear, with a lifting device. If it is possible to lift the rear axle, this function must be disabled. Apart from different specifications for specific individual vehicles, the following may be taken to be the minimum values for the front axle: - 25% of the total vehicle weight with uniformly distributed loads. - 30% of the total vehicle weight for loads that are concentrated on the rear overhang.
The rear overhang of the body must be built in strict observance of the permitted axle loads, the limitations in length, the positioning of the tow hook and of the underride guard stipulated by the relevant laws and regulations. Variations in the Permissible Mass Special exceptions to the maximum permissible wight may be granted for particular applications for which, however, precise limitations regarding the use will be imposed in addition to possible vehicle reinforcements. Such exemptions, if they exceed the limits imposed by law, must be authorised by the Administrative Authority. Reduction of the wight allowed on vehicles (de-rating) may mean it is necessary to adjust certain elements.
The request for authorisation must include: - vehicle type, wheelbase, identification number, designated use; - unladen weight distribution on the axles (e.g. vehicles equipped with crane and body) including positions of the centre of gravity of the payload; - proposals concerning the reinforcement of the vehicle components where necessary. Print 603.93.431 Base - July 2006 Revi - June 2007