Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-10 E URO C ARGO E URO 4 - 5 Centre of Gravity: positioning along the vertical plane The height of the centre of gravity of the unladen chassis cab is given in the technical documentation specific to each model (chassis drawing). For testing the vehicle complete with superstructure, the bodybuilder must check that the height of the centre of gravity of the equipment including the payload, or of the entire vehicle when fully loaded, falls within the maximum permitted values. These limits are defined in compliance with the national or international regulations (e.g.

use text from restyling manualEC Directive 71/320 regarding braking) or requested by the Manufacturer to ensure good handling of the vehicle (e.g. transverse stability of the moving vehicle). For the various models, IVECO publishes (on-line and otherwise) the heights of the centre of gravity of the vehicle with cab (see diagram of vehicle with cab in Figura 3.4). Ask IVECO for information regarding the maximum height of the centre of gravity of the complete vehicle when fully laden. Figure 3.6 Verification with full load:

91519 Ht = Wv · Hv + Ws · Hs Wv + Ws Hs = (Wv + Ws) · Ht − Wv · Hv Ws Wv = tare weight of cab vehicle Hv = Height of centre of gravity of cab vehicle ( with payload) Ws = Payload plus tare weight of superstructure Hs = Height of centre of gravity of payload plus superstructure in relation to ground Wt = vehicle mass when fully loaded Ht = Height of centre of gravity of vehicle with full load To check the vehicle with its body but no payload, use above formula but for Ws use only the body kerb weight (The position for Hv will depend on the load and deflection of the suspension). Base - July 2006 Revi - June 2007 Print 603.93.431