FITTING SUPER STRUCTURES 3-16 E URO C ARGO E URO 4 - 5 3.3.3 Elements making up the subframe Longitudinal Runner Profiles The longitudinal of the added structure must be continuous, extending forward to the front of the vehicle to include, the area in front of the front spring rear hanger, and rest on the chassis of the vehicle but not on the brackets. In order to achieve a gradual reduction in the resistant section, the front ends of the longitudinal runner must be tapered upwards at an angle of no more than 30 ° , or tapered in some other equivalent way (see Figure 3.7), ensuring that the front end in contact with the chassis is suitably connected, min radius 5 mm.
Figure 3.7 91136 If the cab’s rear suspension components do not allow the entire runner to pass through, the runner may be shaped as shown in Figure 3.8. This could require the assessment of the minimum resisting section if high flexural moment occurs at the front (e.g. with crane mounted behind cab if operating towards the vehicle’s front). Figure 3.8 91137 The construction of auxiliary frames either wider or narrower than the chassis structure is permitted only in particular cases (e.g. removable containers sliding on rollers operated by mechanical or hydraulic systems).
In these cases a necessary precaution will be that of ensuring a correct transmission of the forces between the auxiliary frame and the side member vertical web. This can be obtained by inserting an intermediate runner profile shaped according to the vehicle’s side member or by applying a stiffened connecting L-section. Base - July 2006 Revi - June 2007 Print 603.93.431