Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-17 E URO C ARGO E URO 4 - 5 The shape of the section of the runner is determined with due consideration to the function of the subframe and to the type of structure that is above it. It is advisable to use open U-sections if the subframe is supposed to adapt itself elastically to the chassis of the vehicle, and to use box-type sections when added rigidity is called for. Proper care must be taken to ensure a gradual passing from the box- type section to the open kind. Some examples on how to achieve this are shown in Figure 3.9. Figure 3.9 91520 There must be continuity between the longitudinal runners of the subframe and the vehicle.

Do not insert rubber elements between the chassis and subframe. The specified dimensions for the longitudinal runners of the various types of body are recommended minimum values that are for vehicles with standard wheelbases and rear overhangs. In all cases, it is possible to use similar sections whose moments of inertia and resistance are no lower. Such dimensions can be obtained from the technical literature supplied by the manufacturer of the runner profiles.

It should be borne in mind that the moment of inertia, apart from being an important factor for the calculation of the share of bending moment to be applied, also represents the most adequate response to the degree of torsional stress required for the specific type of connecting section in use. Therefore, the moment of resistance is a determining factor as regards the stress exerted on the material. Print 603.93.431 Base - July 2006 Revi - June 2007