FITTING SUPER STRUCTURES 3-18 E URO C ARGO E URO 4 - 5 Cross Members An adequate number of cross members, which should be positioned if possible adjacent to the body, mounting brackets are required to brace the two runners of the subframe. The cross members may be of the open type (e.g. C-type) or, if greater rigidity is desired, of the closed type. Suitable gusset plates must be employed at the points of the connection to confer sufficient strength to the connection (see Figure 3.10). In those cases, when greater rigidity is required for the connection, the work procedure may be carried out as illustrated in Figure 3.11.
Figure 3.10 Figure 3.11 91521 91140 Stiffening the Subframe In the case of certain bodies, such as tippers, cement mixers, crane on rear overhang or bodies with a high centre of gravity, the subframe must be additionally stiffened at the rear end. Depending on the degree of torsional stress, this must be done in one of the following manners: - joining the rear section of the longitudinal member by a box-frame construction; - box-frame construction, closed-section cross members (see Figure 3.12); - box-frame construction, crossties (see Figure 3.13); - by applying in addition to the box-frame construction a longitudinal torsion-resistant bar (see Figure 3.14).
As a general rule, the box-frame construction of the longitudinal runners should not be used at the front end. Figure 3.12 91475 Base - July 2006 Revi - June 2007 Print 603.93.431