Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-20 E URO C ARGO E URO 4 - 5 Connection between chassis and counter-chassis 3.4 Connection between chassis and subframe Choosing the Type of Body Mounting The selection of the type of connection to be used - if not provided initially by the Manufacturer - is very important in terms of the subframe providing strength and stiffness, for the appropriate body type.

The subframe connection may be flexible (brackets or clamps) or it may be rigid, resistant to shearing stress (longitudinal or transverse plates); the choice must be made based on the type of body that is to be mounted analysing the stress forces which the additional equipment that is added transmits to the chassis both under static and dynamic conditions. The number, size and type of securing devices properly subdivided over the length of the subframe, must be such as to ensure a good connection between the chassis of the vehicle and the subframe.

The screws and clamps must be of a strength class no lower than 8.8, the nuts must be equipped with devices that prevents them from working loose. The first fixing nut must be located, if possible, at a distance of 250-350 mm from the front end of the subframe. Any connecting points previously existing on the frame of the vehicle must be used first. The compliance with the aforementioned distance for the first mounting must be ensured in cases where the body applies concentrated loads behind the cab and requires additional stability (e.g. cranes, front end tipping gears etc.) in order to prevent overstressing the chassis frame. If necessary, additional fixings must be fitted.

When anchoring the body to the frame, no welding may be done on the frame of the vehicle, nor may holes be drilled on the flanges of the frame. ! In order to improve the longitudinal or transverse securing of the connection, it is permissible to have holes on the flanges of the side members, but only at the rear end of the members, over a length of not more than 150 mm, provided that the anchorage of any cross members that may be present is not weakened (see Figure 3.19). Alternatively, use the connection of Figure 3.20.

Body Mounting Characteristics Flexible joints (see Figure 3.15, Figure 3.16 and Figure 3.18), permit limited movement between the frame and the subframe, and permit the use of two parallel working strong sections. Each bears a part of the bending moment in proportion to its moment of inertia. For the rigid type of joint (see Figure 3.20) between subframe and chassis, a single strong section is obtained, provided that the number and position of the joints are adequate to support the resulting shearing stresses. Base - July 2006 Revi - June 2007 Print 603.93.431