FITTING SUPER STRUCTURES 3-21 E URO C ARGO E URO 4 - 5 When using sheer resisting plates to secure the subframe to the sidemembers, a single strong section is formed which has a higher strength capacity when compared with the connections made using brackets or clamps. This has the following advantages: - Lower height of the subframe profile under the same bending moment acting on the section. - Higher bending moment under the same subframe profile dimensions. - Further increase in the strength capacity, when the subframe is made up of high mechanical characteristic materials.
Subframe dimensions In case of elastic connection between the chassis and the subframe, the bending moment Mf shall be distributed between the chassis and the subframe in proportion to the moments of inertia of the sections:
M M M c t f + = M M c = I I c I M M c f c t t c c c t M = σ ≤ = σ + x I I W amm c I M M t f t = σ ≤ = σ + x t t c t M I I W amm t M f = static bending moment generated by the superstructure (Nmm) M c = additional dimension of the static bending moment Mf applied to the subframe (Nmm) M t = additional dimension of the static bending moment Mf applied to the chassis (Nmm) I c = moment of inertia of the subframe section (mm 4 ) I t = moment of inertia of the chassis section (mm 4 ) σ c = maximum static stress applied to the subframe (N/mm 2 ) σ t = maximum static stress applied to the chassis (N/mm 2 ) W c = section modulus of the subframe section (mm 3 ) W t = section modulus of the chassis section (mm 3 ) σ amm = maximum static stress permitted on the chassis (N/mm 2 ) Example of stress calculation in case of elastic connection with the chassis Consider two C-section bars with the following dimensions 3.
chassis: 250 x 70 x 5mm 4. subframe: 140 x 70 x 7mm and stressed, at a given section, by the maximum bending moment Mf equal to 15000 Nm as applied in a perpendicular direction to the plane containing the side-member rib. From the calculation, the following values will be obtained: I x (cm 4 ) W x (cm 3 ) 1. chassis 1545 123 2. subframe 522 74 By applying the formulas, the following will be obtained: 1. M t = M f x [I t / (I c + I t )] = 8500 x [588 / (588 + 183)] = 11200 Nm 2. M c = M f x [I c / (I c + I t )] = 8500 x [183 / (588 + 183)] = 3790 Nm Thus 1. σ t = M t / W t = 91N/mm 2 2. σ c = M c / W c = 51N/mm 2 Print 603.93.431 Base - July 2006 Revi - June 2007