FITTING SUPER STRUCTURES 3-22 E URO C ARGO E URO 4 - 5 In case of rigid connection (cut resistant plates) between the chassis and the subframe, the bending moment M f shall be applied to the single chassis-subframe section.
= σ ≤ = σ max t t amm f t M I W Wt y = σ ≤ = σ f c M I W W max c c amm c y σ c = maximum static stress applied to the subframe (N/mm 2 ) σ t = maximum static stress applied to the chassis (N/mm 2 ) M f = static bending moment generated by the superstructure (Nmm) I = moment of inertia of the single chassis-subframe section (mm 4 ) σ amm = maximum static stress permitted on the chassis (N/mm 2 ) y t max = distance from the neutral stressing axis of the chassis outermost fibres (mm) y c max = distance from the neutral stressing axis of the chassis outermost fibres (mm) Example of stress calculation using cleat plates to the chassis Consider two C-section longitudinals with the following dimensions 1.
chassis: 250 x 70 x 5mm 2. subframe: 140 x 70 x 7mm and stressed, at agiven section, bythe maximum bendingmoment Mf equal to 15000 Nm asapplied in aperpen- dicular direction to the plane containing the side-member rib. From the calculation, you will obtain that the center of gravity lies approximately 28 mm from the contact segment from the part of the section 250 x 70 x 5 mm (chassis). Thus: 1. y t max = 250 - 28 = 222 mm 2. y c max = 140 - (-28) = 168 mm Moreover I x (cm 4 ) W t (cm 3 ) W c (cm 3 ) 1. chassis+ subframe 5643 254 334 By applying the formulas, you will obtain: 1. σ t = M f / W 1 = 59 N/mm 2 2. σ c = M f / W 2 = 45 N/mm 2 Base - July 2006 Revi - June 2007 Print 603.93.431