FITTING SUPER STRUCTURES 3-23 E URO C ARGO E URO 4 - 5 3.4.1 Connection with Brackets A few examples of this type of connection (flexibility mounting), are shown in Figure 3.15. Figure 3.15 1 Subframe 2 Frame 3 Shims In order to ensure a flexible joint there must be a gap of 1-2 mm between the brackets of the frame and those of the subframe before the securing bolts are tightened. When tightening the securing bolts, brackets shall come in contact. Initial gaps larger than 1-2 mm are to be reduced by using suitable shims. Using bolts of proportional length improves the flexibility of the connection.
The brackets should be fitted on the web of the side members of the vehicle with screws or bolts. In order to guide and better contain the loads transversally, a slight protrusion of the brackets above the chassis is recommended. When the brackets are fitted flush with the upper flange of the side member, the lateral movement of the body structure must be secured by other means (e.g. using guide plates the chassis connected). When the front connection is of the elastic type (ved. Figure 3.16), lengthwise securing must be ensured even in the conditions of maximum twisting of the chassis (e.g. off-road). Use the stake pockets fitted on the chassis for IVECO bodies to mount the structure.
The brackets fitted to the subframe or to the body must have characteristics of strength not lower than those of the original brackets fitted to the vehicle. 91478 Print 603.93.431 Base - July 2006 Revi - June 2007