Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-24 E URO C ARGO E URO 4 - 5 3.4.2 Connection with Greater Elasticity Since there is no clear definition for a torsionally rigid body or indeed the arduousness of a vehicle mission, such flexibility is required for all body types except for special applications (e.g. crane mounting). A helical spring is available from Iveco Parts Departments and should be used at the first and second body mounting brackets each side. The detail of the body mounting and installation is as follows:

Figure 3.16 Spring stiffness = 424 N/mm - With the longitudinal hard on the top flange there must be agap of 5mm between the faesof the two brackets before the upper bracket is fixed to the longitudinal. - The body securing bolt should be 14mm diameter grade 8.8 and secured with lock nuts. - Flat washers 4mm thick by 32mm outside diameter (minimum in both cases) should be fitted between the spring and the head of the bolt and between the lock nut and the frame bracket. When using rubber inserts, use materials which gives a good working life (elasticity). The relevant instructions for regular inspections of the body mounting for deterioration and the bolt torque must be given to the operator.

Figure 3.17 Element rubber The whole connection capacity can, if necessary, be re-established by fitting shear resisting plates from the rear spring front hanger brackets to the end of the frame instead of the normal factory body brackets. On installations where the veicle is supported by means of hydraulic stabilisers (e.g., cranes, lifting platforms), the movement of the elastic connection should be limited to 30 ч 40 mm to ensure sufficient co-ordinated movement of the subframe and avoid excessive bending moments on the original chassis. Base - July 2006 Revi - June 2007 Print 603.93.431