Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

Print 603.93.431 Base - July 2006 Revi - June 2007 EUROCARGO EURO 4 - 5 FITTING SUPER STRUCTURES 3-35 Installation of Concrete Mixers 3.11 Installation of Concrete Mixers Concrete mixers may be installed only on vehicles that are suitable for this purpose as indicated in Table 3.9, where also the minimum requirements for the reinforcing sections and the drum capacity is given. It is clear that the maximum permissible weight for the vehicles must be respected. In addition to observing all the possible government regulations relating to the installation of concrete mixers the following points must be kept in mind:

- the concrete mixer must be fitted with its own continuous steel subframe in observance of point SENZA CODICE, so as to distribute the concentrated weight as much as possible over the chassis. For the runners of the subframe, sections with a moment of resistance (Wx) and a moment of inertia (Jx) not lower that those for the sections may be used, which permit substantial reductions in the height of the added structure’s centre of gravity (i.e.

boxed-type structures or sections with the upper flange turned toward the outside see Figure 3.23); - suitable cross members must be provided to ensure adequate rigidity in the mounting between the cement mixing apparatus and its basic frame, so as to free the vehicle’s chassis from the forces that result from the particular geometry and functional configuration of the concrete mixer.

The subframe must be suitably stiffened towards the rear with appropriate crosspieces or crossbraces; Table 3.9 Approximate capacity of drum Minimum profile of subframe Model (m3) Strength modulus Wx (cm3) Dimensions (mm) 140EK-150EK-160EK 3-3.5 83 140 x 80 x 7 180K 4-5 92 140 x 80 x 8 Figure 3.23 91486 1 Main frame 2 Regular channel profile 3 Runner with upper flange turned over 4 Position of drum