FITTING SUPER STRUCTURES 3-34 E URO C ARGO E URO 4 - 5 Removable Containers 3.10 Removable Containers Not all vehicles lend themselves equally well to be used for removable type containers (i.e. the containers which can be unloaded by sliding along to subframe). Heavy duty vehicles are certainly better suited to this use but it is best to consult IVECO concerning the suitability of the various models in relation to the use of the vehicle. This type of operation is subject to additional stresses compared to those of normal on-road vehicles with fixed platform bodies, in particular as regards loading/unloading operations.
For this reason, the auxiliary frame used (see point 3.9.2) should be of the same dimensions as that for light tippers. Where vehicles with long wheelbases or rear overhangs are used, it may be necessary to use runners of larger dimensions for the subframe. The lifting devices must be anchored to the subframe as indicated in point 3.4. The stability of the vehicle must always be ensured during loading and unloading operations. We recommend fitting the rear ends with supports (stabilisers) that are to be used during loading/unloading, particularly when roll on/roll off containers are used. These supports are also recommended if the rear axles have pneumatic suspensions.
As an alternative, refer to the explanations in point 3.9.2, concerning dumping the air from the suspension during the operation. It is very important, with this type of vehicle, to adhere to the specifications concerning the height of the centre of gravity (see point 3.2), when containers high payloads are used. Figure 3.22 91532 The distance between the last rear axle and the sliding pin must not exceed 900 mm. Base - July 2006 Revi - June 2007 Print 603.93.431