Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-33 E URO C ARGO E URO 4 - 5 3.9.2 Light-duty Service For these operations we recommend using vehicles with short wheelbases. In Table 3.8 are listed the longitudinal runners to be used. It is understood that the vehicle must be used for light duty on good roads, to transport freight with a low density and a low coefficient of friction. In addition to the above general specifications, in order to give the vehicles the required rigidity and stability, the following points must be observed:

- carefully check the chassis specifications (suspension, chassis, number of axles) to select a body suitable for the vehicle and its intended operation; - the rear end of the auxiliary frame must be stiffened using e.g. box-type sections, crossbraces, cleat plates etc; - the rear tipping hinge must be placed as near as possible to the rear support of the rear suspension; - in cases of vehicles having wheelbase longer than the standard tipper wheelbase, specially stiffened rear tipping support anchoring should be used so as to contain sag and ensure good stability during operation.

The rear tipping angle should not exceed 45є while the user should be informed that the tipping should be done on as flat a surface as possible; - use the most rigid rear suspensions available. When parabolic rear springs are used, the stiffness should be increased using rubber elements that operate at static load; - in vehicles with pneumatic rear suspension, discharge of air from the springs must be foreseen during tipping, in order to improve stability in the suspensions while the material is being unloaded.

- on vehicles with standard third axle or added third axle (6x2), an antiroll bar may have to be fitted onto the 3rd axle depending on the type of installed suspension to improve the transverse stability. In addition to the above instructions, hydraulic or mechanical stabilisers may have to be installed for operation depending on the tipping support location in relation to the rear axles, to suspension types and to intended operation. The third axle must never lift when tipping.

Table 3.8 - Minimum subframe profile dimensions TT = All wheelbase Print 603.93.431 Base - July 2006 Revi - June 2007 Minimum profile of subframe Strength modulus Wx (cm3) Dimensions (mm) Mo d el Wheelbase Yield limit of material used (N/mm2) 240 360 240 360 T T ------ 26 ------ 80E, 90E, 100E T T 39 ------ 120 x 60 x 5 ------ T T 57 ------ 140 x 60 x 6 120E T T ------ 31 ------ 100 x 60 x 5 T T 46 150E - 160E T T 69 46 160 x 60 x 6 120 x 60 x 6 T T 69