FITTING SUPER STRUCTURES 3-37 E URO C ARGO E URO 4 - 5 Installation of Tanks and Containers for Bulk Materials 3.12 Installation of Tanks and Containers for Bulk Materials As a general rule, the installation of tanks and containers on our vehicles requires the use of an appropriate auxiliary frame. Table 3.10 contains the guidelines for the dimensions of the longitudinal runners to be used for the auxiliary frame. Table 3.10 Tankers , or more generally, structures which are torsionally very rigid, must be fitted so that the vehicle chassis retains sufficient and gradual torsional flexibility, by avoiding areas of high stress.
When installing a tank we recommend using elastic joints (see Figure 3.25) between the body of the tank and the auxiliary frame in front and rigid supports that are capable of withstanding longitudinal and transverse forces in the rear. Figure 3.25 91493 As was mentioned in the case of other applications, the positioning of the mountings through which the forces are discharged is similar here. The rigid mounts go in a position corresponding to the rear suspension supports and the flexible mounts as near as possible to the rear support of the front suspension.
When faced with a different situation, a possible solution could be that of reinforcing the structure by means of longitudinal runner profiles of larger dimensions in comparison with those given in Table 3.10. Other type of body connections can be permitted upon request. In order to define the elastic connection, the rigidity characteristics of the vehicle chassis as well as the area where the connections are to be installed and the type of use for which it is intended must be taken into account.
Print 603.93.431 Base - July 2006 Revi - June 2007 Minimum profile of subframe Model Strength modulus Wx (cm3) Dimensions (mm) 46 80E, 90E, 100E, 110EL, 120EL 57 140 x 60 x 6 89 180E, 190E 99 160 x 70 x 8