Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-38 E URO C ARGO E URO 4 - 5 As a rule, for road use, it can be said that the first front elastic mounting will allow for a gap of approximately 10 mm between the subframe and frame during the chassis torsional stage. Tanks may be mounted directly onto the vehicle chassis without fitting an auxiliary frame under the following conditions: The fitting of tanks directly onto the vehicle chassis without a subframe must be authorized by IVECO on each occasion after submission of the required documents: - the distance between saddles must be determined depending on the load to be discharged.

In any case it must not exceed 1 meter; - saddles must be fitted so as to allow an even distribution of the loads over a considerably large surface. Suitable brackets must be provided between the saddles to limit the longitudinal and transverse thrusts; - other anchoring solutions may be authorised by IVECO; - self-bearing tanks may be positioned directly on the chassis by means of suitable mountings located right behind the cab and in the rear axle(s) area. Their amount and distribution depend on the number of axles and the wheelbase; they may vary from min. 2 for each side on 2- axle vehicles with short wheelbases to min. 3 for 3-axle vehicles with short wheelbases Figure 3.26).

The anchoring devices must be sufficiently long (600 mm approx) and be positioned next to the suspension mountings (max. distance 400 mm). To permit the necessary torsional movements of the chassis, elastic front mountings should be used where possible. Other solutions are possible depending on the type of construction. Figure 3.26 91494 Base - July 2006 Revi - June 2007 Print 603.93.431