Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-40 E URO C ARGO E URO 4 - 5 Installation of Cranes 3.13 Installation of Cranes The selection of the crane must be made with due consideration to its characteristics (weight, maximum torque) in relation to the performance of the vehicle. The positioning of the crane and of the payload must be done within the load limits permitted for the vehicle. Installation of the crane must be carried out in compliance with statutory requirements, national standards (e.g. CUNA, DIN) and international standards (e.g.ISO, CEN), depending on which of these is pertinent to the particular vehicle. Use stabilisers while the crane is operating.

As a general rule, the installation of a crane requires the use of a suitable subframe, whose construction must take into account all general specifications relating to it (point 3.3). Concerning the dimensions of the runners for the subframe, refer to Tables 3.11, 3.12 and 3.13. The dimensions of the subframe refer to the total maximum static moment of the crane ( M G max .) which is calculated on the basis of the equation given in Figure 3.27.

In those cases where no specific subframe is called for (value A on the table) it is still necessary to provide a suitable mounting on the chassis for the crane using the standard body subframe (the section members must be in length at least 2.5 times the width of the base structure of the crane) in order to distribute the load and the stress developed during the operation of the crane. If the vehicle requires the use of its own subframe, it may also be used for the crane provided that its dimensions are adequate. Particular cases in which the values of the M G moment are matched by value E” in the table (or for higher MG values) must be checked on a case-to-case basis.

Special approval must be requested from IVECO. Figure 3.27 M G [ KNm ] = max  g ⋅  W L ⋅ L + W c ⋅ l  1000  91541 g = acceleration of gravity, equal to 9.81 m/s 2 ; W L = load applied to the crane end (kg); L = horizontal distance between the point where load W L is applied and the vehicle center line [ m ] ; W c = crane’s own weight applied to its center of gravity [ kg ] ; l = horizontal distance between the center of gravity of the crane and the vehicle center line [ m ] ; Base - July 2006 Revi - June 2007 Print 603.93.431