Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-41 E URO C ARGO E URO 4 - 5 The bodybuilder must check the stability of the vehicle each time during the phases of work, according to current regulations, taking all the necessary precautions to ensure proper use. Both the crane manufacturer and the body builder are to define the type and number of the stabilizers and make the subframe depending on the maximum static moment and the crane position. !

3.13.1 Crane Behind the Driver’s Cab The mounting of the subframe onto the chassis frame will as a rule, be performed by using the standard brackets (see Figure 3.28) to which are added, if necessary, other flexible anchorages (brackets or clamps) so that the flexibility and torsional characteristics of the chassis frame remain unchanged. The dimensions and the subframe to be used for this type of installation are specified in Table 3.11. For on-road vehicles only, if the height of the subframe runner profile has to be reduced (e.g. to lower the total height of the vehicle) the mounting of the subframe may be carried out with shear resisting connections (see Figure 3.29).

For these applications, the minimum dimensions of the reinforcing runner are specified in Table 3.12. The use of runners with a constant cross-section is recommended over the entire useful length of the vehicle. Any possible gradual reduction of the cross-section of the runners is permissible in those areas in which the flexional moment induced by the crane assumes values that correspond for those of boxes marked ”A”in Table 3.11 and Table 3.12.

The crane subframe, as indicated in Figure 3.28, can be fixed at the rear to the one foreseen for other superstructures; the length “Lv” must in any case be not less than 35% of the wheelbase; this is in cases where the superstructure profiles have a lower cross-section. Figure 3.28 91534 1 Subframe 2 Connections 3 Crane joints 4 Stabilisers Print 603.93.431 Base - July 2006 Revi - June 2007