FITTING SUPER STRUCTURES 3-43 E URO C ARGO E URO 4 - 5 Figure 3.29 91497 When mounting cranes on vehicles with large cabs (double cab or 6+1), should it be impossible to extend the subframe up to the rear support of the front spring, it may be necessary to contain crane rotation according to crane capacity, so as not to exceed bending moment allowance for the chassis. Installation of cranes on off-road vehicles may require fitting elastic mountings between the chassis frame and subframe on the front and central areas (see Figure 3.16) so as not to excessively constrain the chassis torsional movement.
Since in such cases the crane will be virtually connected to the subframe only, the size of the longitudinal runners must be adequate to resist the crane operation-generated movements. The functioning of the equipment that is placed behind the cab (e.g. gear levers, air filter, locking device for the tilting cab etc.) must not be impaired. Relocating assemblies such as batteries box or fuel tank is permissible provided that the original type of connections are re-established. Normally, when the crane is placed behind the cab, it is necessary to move the platform body or equipment to the rear.
In the specific case of tipping equipment, particular care must be given to the placement of the lifting device and of the rear tipping hinges which should be moved back as little as possible. Print 603.93.431 Base - July 2006 Revi - June 2007