Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-46 E URO C ARGO E URO 4 - 5 3.13.2 Crane on Rear Overhang It is advisable for this type of application, to extend the subframe over the entire length of the vehicle that is available for the body up to the rear support of the front spring. The dimensions of the runners to be used are given in Table 3.14. In consideration of the particular distribution of the load on the vehicle, wherein the load is concentrated on the rear overhang, and in order to ensure the rigidity that is necessary for good performance on the road and when the crane is in operation, the subframe must be strengthened and stiffened in relation to the capacity of the crane.

Box-type construction sections (see point 3.3) and brackets are to be employed in the area corresponding to the rear suspension and the rear overhang (Length Lu) - see Figure 3.31. Care must also be taken to ensure that the transition from box-type to open section be well blended as illustrated in Figure 3.9. In the area that is affected by the box-type section, the frame must be secured to the chassis of the vehicle by means of shear-resistant joints (i.e. an adequate number of plates spaced at most 700 mm from each other), whereas elastic anchorages are to be used in the front part.

Due care must be taken to ensure that under any load conditions, the ratio of the load on the front axle to the rear axle or axles, respects the limits set for the vehicle (see point 3.2). As the required stiffness of the subframe depends on various factors (i.e. crane capacity, size of its supporting base, vehicle kerb, chassis overhang) we cannot give information valid for all possible different conditions. For this reason the bodybuilder will have to assess the vehicle stability also by means of practical behavioural tests. If, as a consequence of such tests , the subframe stiffness proves insufficient, the bodybuilder will have to achieve this objective by means of alternative methods.

The rear overhang of the crane (length Lu, see Figure 3.31), must be limited as much as possible in order to preserve the good driving characteristics of the vehicle and acceptable stress conditions. This value must not exceed 50% of the wheelbase. In the case of vehicles with an added lifting rear axle, the verification of the minimum load on the front axle must be done with the rear axle in the raised position in those countries which permit driving under those conditions (see point 3.7). If the minimum prescribed value is not reached, the vehicle must be allowed to drive only with the axle in the lowered position. Base - July 2006 Revi - June 2007 Print 603.93.431