FITTING SUPER STRUCTURES 3-49 E URO C ARGO E URO 4 - 5 Installation of Tail Lifts 3.14 Installation of Tail Lifts The dimensions of the reinforcing runners to be used when installing tail lifts can be assessed as follows: - By means of Table 3.16, with the standard rear overhangs and mean bending moments induced by tail lifts; as a function of theircapacity . In the table, the minimum capacityvalues are specified above which suitable stabilisers must be used. - When cantilever tail lifts or with different lengths of the rear overhang and with special tail lifts(e.g.
of aluminium), the flexural moments induced on the chassis frame can be assessed by means of Figure 3.32, whereas the characteristics of the reinforcing runners can be defined with the relevant Table 3.17. The bodybuilder or the Manufacturer of the tail lift will take care to ascertain safety and operational stability, in particular when applying Table 3.17. In any event, particularly in those specific uses where there is not suitable auxiliary frame (as in the case with bodies shear resisting plates built by means of cross members), the anchoring for the loading platform must be provided by a structure that enables the stress to be distributed over the chassis of the vehicle.
To provide the necessary strength and rigidity, the connection between the chassis and the auxiliary frame must involve (especially in overhangs of over 1500 mm) the use of shear resisting plates positioned in the area of the overhang and of the rear suspension and spaced not more than 700 mm from one another as shown in Figure 3.32). Figure 3.32 REAR AXLE CENTRE LINE 91538 W TL = Weight of tail lift W L = Tail lift capacity The bending moment on the chassis can be obtained from the formulas below: M [ Nm ] = W L x A + W TL x B for tail lifts without stabilisers M [ Nm ] = W L x C + W TL x D for tail lifts with stabilisers Print 603.93.431 Base - July 2006 Revi - June 2007