Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

POWER TAKE-OFFS 4-5 E URO C ARGO E URO 4 - 5 General specifications 4.1 General specifications Various types of power take-off can be fitted to provide drive to command auxiliary units such as tippers, cranes, compressors, municipal vehicles, etc.. Depending on the type of use and the performance level required, the application may be applied to: − the gearbox (or torque distributor) − transmission − the front of the engine The characteristics and performances are given in the paragraphs which follow and in the relevant documentation which will be supplied upon request.

For the definition of the power necessary for the apparatus to be controlled, particularly when the values requested are high, the absorbed power should also be considered during the drive transmission phase (5 to 10% for the mechanical transmissions, belts and gears, and greater values for the hydraulic controls). The choice of transmission ratio for the power take-off should be made so that the absorption of power occurs in a flexible engine operating range: low r.p.m. (below 1,000 r .p.m.) must be avoided to prevent irregular running. The amount of power drawn off can be obtained using the following ratio:

P(CV) = M ⋅ n ⋅ i P(kW) = M ⋅ n ⋅ i 7026 9552 P = power drawn off n = engine rotation speed (r.p.m.) Mmax= Maximum torque that can be drawn (Nm) i = gear ratio = PTO outlet revs / engine revs Type of utilization The values of the maximum torque that can be drawn M max refer to continuous utilization (up to 60’). Any higher value for occasional utilization (less than 30’) shall be agreed upon each time depending on the type of utilization. In case of utilization of more than 60’, you shall consider to reduce, if necessary, the values established depending on the conditions of use (engine cooling, gearbox, etc.).

The scheduled take-off values are also applicable for uses which do not involve large variations of torque either in frequency or magnitude. To avoid overloading it may be necessary, in certain cases (e.g.: hydraulic pumps, compressors) to fit devices such as clutches or safety valves. General specifications Print 603.93.431 Base - July 2006 Revi - June 2007