POWER TAKE-OFFS 4-6 E URO C ARGO E URO 4 - 5 Transmissions The kinematic forces of the transmission from the power take-off to the relevant apparatus should be carefully considered (angles, r.p.m., torque) during the design phase and the dynamic behaviour during operation in compliance with the transmission Manufacturer’s instructions should be respected. The dimensions should take into consideration the forces which might occur under maximum power and torque conditions. To obtain a uniformity of kinetic forces angles of equal value, maximum of 7є, should be obtained at the extremities (see Figure 4.1).
Solution Z is preferred to solution W due to the lower loads on the bearings of the power take-off and the equipment being driven. When it is necessary to obtain different spatial inclinations ( ϕ ), the variations in r.p.m. should be compensated for with the arrangement of the forks shown in Figure 4.2. For transmissions employing multiple sections, the instructions given at point 2.8.8 should be followed. Figure 4.1 Solution Z Solution W 91522 Figure 4.2 91523 General specifications Base - July 2006 Revi - June 2007 Print 603.93.431