Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

SPECIAL INSTRUCTIONS FOR EUROCARGO -SCR- EXHAUST SYSTEMS 6-9 E URO C ARGO E URO 4 - 5 Distribution of the main SCR system components fitted onto the vehicle 6.4 Distribution of the main SCR system components fitted onto the vehicle 6.4.1 Assembly and disassembly instructions Figure 6.7 108588 LOCATION OF THE SCR SYSTEM COMPONENTS ON THE VEHICLES 1. Intake air humidity detecting sensor - 2. Pump module (Supply Module) - 3. Reacting solution tank (water, urea: AdBlue) - 4. Catalyzer - 5. Catalyzer infeed exhaust gas temperature sensor - 6. Catalyzer outfeed exhaust gas temperature sensor - 7.

Mixing and injecting module (Dosing Module) The instructions that follow are intended for the AdBlue injection system of the Bosch DENOX2 type, within the SCR system. These instructions must be complied with especially in case of modifications carried out on the chassis by bodybuilders. In any event, as a general rule, during assembly and disassembly of the AdBlue system components, follow the procedures below: - disassembly: disconnect the hydraulic connectors first and then the electric connectors. - assembly: connect the electric connectors first and then the hydraulic connectors.

Compliance with this assembly/disassembly procedure will ensure that AdBlue does not come into contact with the electric connectors. Distribution of the main SCR system components fitted onto the vehicle Print 603.93.431 Base - July 2006 Revi - June 2007