Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-54 E URO C ARGO E URO 4 - 5 Cab Modifications 2.17 Cab Modifications 2.17.1 General Specifications Any work on the driver’s cab must be authorised previously by IVECO. Modifications must not prevent operation of the control devices located in the area affected by the modifications (e.g. pedals, linkages, switches, pipes etc) or alter the strength of the load- bearing elements (uprights, reinforcement sections etc.). Due care must be taken when carrying out work that may affect the cooling system and air inlet pipes of the engine.

The variations in the weight of the cab as well as its different depth must be considered when positioning the payload, in order to ensure correct distribution of the permitted weights on the axles (see point 3.2). For operations that require the removal of sound deadening panels or internal protective elements (panelling, padding) restrict the removal to the absolute minimum, taking care to restore the protective elements to their original condition, ensuring the previous operating capability. Controls and equipment (power take-off engagement control, external operating cylinder control etc.) may be fitted in the cab provided that:

- They are positioned rationally, properly and are easily accessible to the driver. - Safety, control and warning devices are fitted which meet the requirements of use and safety of the vehicle and its equipment as well as the requirements of national legislation. Ensure that the pipes and wires are correctly positioned particularly when the cab is tilted. Use the necessary fixings taking care to observe the appropriate distances from the engine, heat sources and moving parts. Provide the necessary protection from corrosion for all modifications to the structure (see point 2.2). Ensure that the seals are fitted correctly and apply sealant to those areas which require it.

Ensure that a perfect seal is provided against the infiltration of water, dust and fumes. The bodybuilder must check that after modification, the cab satisfies legal requirements regarding both the inside and outside of the vehicle. 2.17.2 Roof Panel Modifications Installation and modification work to achieve specific refurbishments must be carried out with great care to safeguard the strength of the cab and ensure that its operation and protection are maintained. When fitting assemblies or systems onto the roof (e.g. air conditioning systems, spoilers, top- sleepers), check that the weight of the appliance does not exceed that permitted for the cab.

These limits will be provided upon request depending on the assembly or system to be fitted. The cabs are provided with anchorage points along the roof sides (8 points on the day cab and 10 points on the sleeper cab) having threaded holes M8xI protected by plastic plugs. Should it be necessary to make an opening to form a roof compartment, ensure that - The connection radii are not less than 50mm - Do not modify any ribs that may be present - Do not change the curvature of the roof. Cab Modifications Base - July 2006 Revi - June 2007 Print 603.93.431