Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-55 E URO C ARGO E URO 4 - 5 2.17.3 Installation of a Spoiler or a Top-sleeper Upon request, the various versions designed by IVECO can be delivered with relevant instructions for installation. It is recommended that these versions are used as they are specifically checked. The installation of other versions will be carried out in the same way as prescribed for the original ones by using the anchorage points placed on the roof sides resting on devices of adequate dimensions. Moreover, the instructions of the manufactures of the add-on assemblies are also to be met. Their positioning must not impair the correct operation of the engine air intake system.

Whenever national regulations require it, these installations will be inspected by the responsible agencies. 2.17.4 Crew Cabs When making crew cabs, cabs for special vehicles, for municipal use, fire fighting etc. check whether the cab’s suspension requires uprating due to the increase in weight, also taking into account any extra seating arrangements made. Before work of this type can be started on tilting cabs, IVECO’s approval is required to confirm whether the original suspension, tilting and locking devices are suitable. As a rule, solutions equivalent to those designed by IVECO for similar versions may be adopted.

In order to help preserve the integrity and rigidity of the cab, we recommend that, as far as possible, the rear structures are kept intact. The cut may be made at the side, taking care that the door opening remains intact. The bodybuilder must make the necessary connections to the load- bearing structure, comprising the longitudinal runners and uprights and connect the new floor to the existing structure. Provide inspection panels if necessary. Take particular care when preparing the surface of the elements to be welded by applying a zinc primer, taking the necessary precautions to ensure that the primed surface is properly prepared for subsequent painting (see point 2.2).

Wheneverthe cab hasto remain of the tiltingtype, the following points will be taken into consideration depending on the increase in cab weight: - Modify the tilting devices. - Restore the cab locking devices. - Decrease the tilting angle. - Adapt the suspension. For the cab tilting system, a cylinder of greater capacity with relevant resting devices can be installed or a supplementary one fitted taking care to maintain the required clearance from the adjacent components. The area affected by the thrust of the hydraulic devices must be such to avoid an excessive concentration of stress. For this purpose ensure that: - The lifting points are positioned as far back as possible.

- There are suitable anchorage points both on the cab floor and vehicle chassis. Cab Modifications Print 603.93.431 Base - July 2006 Revi - June 2007