CHASSIS MODIFICATIONS 2-58 E URO C ARGO E URO 4 - 5 Modifications to the Braking System 2.19 Modifications to the Braking System 2.19.1 General Specifications The braking system with its components represents an element of crucial importance to vehicle safety. ! Itisprohibited to make changesto unitssuch asthe brakecontrol system,distributor, brake cylinders, valves, etc, which are rated as safety components. Any modification to the braking system (modification of pipes, fitting additional operating cylinders, etc.) must be authorised by IVECO. For new equipment we recommend the same make as those fitted to the original vehicle.
When required by national regulations, the vehicle must be submitted for testing to the respective authority. In the event of the regulating valves, air drier etc., being moved, reinstate the same type of installation as originally envisaged, verifying correct operation. In addition, operations carried out on the air drier must not affect cooling of the air supplied by the compressor. If the drier has to be repositioned, of if the body reduces the drier ventilation or intake lines (i.e. from the compressor), then the drier intake temperature (measured at the section of intake hose next to the drier) must never be more than 65 ° C in all vehicle use conditions.
Hoses must not be lungthened in a manner that will create a siphoning effect. The length of the original intake hose is to be taken as the minimum length. Do not place on the chassis, equipment that could hamper the replacement of the drier cartridge. ! 2.19.2 Brake Pipes Pipes must never be welded. ! When the wheelbase or rear overhang of the chassis are modified, the brake pipes concerned must be replaced by a single length of new pipe. Where this is not possible the connectors used must be of the same type as those used originally on the vehicle. When replacing observe the minimum internal dimensions of the existing pipes.
The new pipes must have the same characteristics and be of the same material as those used originally on the vehicle. The installation must be carried out so that the piping is protected and the correct function of the system ensured. For the supply and fitting of material we recommend that you contact our Parts Centres or specialised workshops. Modifications to the Braking System Base - July 2006 Revi - June 2007 Print 603.93.431