CHASSIS MODIFICATIONS 2-59 E URO C ARGO E URO 4 - 5 Metal Pipes For the hydraulic system pipes and those between the air compressor and adjustment units, any additions and replacements must be as follows: - Brake pipes (material, size, connectors) : according to ISO 4038 Standard - Compressor pipes (material, size, connectors) : according to DIN 3901 - Curvature radii (referred to pipe centreline) : minimum 2 x outer dia. - Tightening torque brake pipe dia. 6x4 (connectors M 12x1) : 20 Nm Compressor pipes dia. 19x15 (connectors M26x1.5) : 90 Nm Plastic Pipes When fitting new pipes or replacing others, plastic must not be used for the following:
- in areas where the temperature reaches more than 80 ° C (e.g. within 100 mm of the engine exhaust system) - between fixed and moving parts, in this case special hoses are to be used - on the hydraulic lines. During modification the following must be observed: - Material and dimensions : Standard DIN 74324 (Iveco Standard 18-0400) (max. operating pressure 11 bars) - Radii of curvature : min. 6 x outer dia. (referred to the pipe centreline) Modifications to the Braking System Print 603.93.431 Base - July 2006 Revi - June 2007