Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-66 E URO C ARGO E URO 4 - 5 As a rule quick coupling connectors should be used. We recommend that the same makes present on the original vehicle be used. When necessary (e.g. near bends), connectors with metal inserts may be used. Before inserting the pipe into the connector the latter must be screwed into its threaded seat on the component (e.g. pneumatic valve) adopting the tightening torques indicated below: Table 2.17 Insert the portion of the length L, previously marked, of the pipe into the connector applying force for 30 to 120 N depending on the dimension of the pipe.

The replacement of the components (valves etc.) is made possible since the coupling and connector may be internally rotated while screwing or unscrewing. Should piping be replaced: 1. If the connectors are of the Raufoss P5 type, use new connectors. 2. If the connectors are of the Voss 214 type, disassemble them using the special pliers, then re-fit them on the new piping. ! Installing pipes on vehicle New pipes must be thoroughly cleaned inside before use (e.g. by blowing through with compressed air). Pipes must be fixed in their correct position. The fixing clips must go right round the pipe. They may be of plastic, metal or rubber.

Observe adequate distances between the various fixing elements. As a rule a maximum distance of 500 mm for plastic pipes and 600 mm for metal pipes is applicable. For plastic pipes, in order to prevent distortion and tension on the connectors when fitting them, take the necessary precautions when working out the run and fitting the fixing brackets onto the chassis. Correct fitting of the fixing brackets will ensure that the pipes do not rub against the fixed parts of the chassis. Observe the necessary safety distances from moving parts and heat sources. When a pipe has to pass through the chassis frame (side or cross members) appropriate precautions must be taken to avoid damage.

Modifications to the Braking System Base - July 2006 Revi - June 2007 Print 603.93.431 Thread Tightening torque (Nm ± 10%) M 12 X 1.5 mm 24 M 14 X 1.5 mm 28 M 16 X 1.5 mm 35 M 22 X 1.5 mm 40