CHASSIS MODIFICATIONS 2-67 E URO C ARGO E URO 4 - 5 A solution which can be used as a bulkhead connection for a straight or angled run is given in Figure 2.28: Figure 2.28 91464 1. Pipe 2. Bulkhead connector 3. Chassis After completing any work either on the system or the equipment, the braking system must be checked to ensure its efficiency. For air systems, build up the pressure to its maximum value. Check for leaks in the areas affected by the work carried out. ! 2.19.3 Vehicles with ABS When modifying the wheelbase, the ABS modulators must be kept in their original position with respect to the rear wheel axle.
The electrical wires between the sensors on the rear axle and the control unit and between the unit and modulators must be modified accordingly by using new wires or extensions with appropriate connectors should there be insufficient length in the originals. Brake pipes upstream of the modulators must be similarly modified. Modifications to the Braking System Print 603.93.431 Base - July 2006 Revi - June 2007