Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-73 E URO C ARGO E URO 4 - 5 2.21.4 Installing additional equipment When fitting additional equipment, where necessary, diodes must be fitted to provide protection against any induction current peaks. The earth signal originating from analogue sensors must only be wired to a specific receiver. Additional earth connections could result in false output signals being emitted from these sensors. The wiring looms for the electronic components with low intensity signals must be arranged in parallel to the metal datum plane i.e. it must adhere to the chassis/cab structure in orderto reduce the parasite capacity.

It should be spaced from additional wiring looms as far as possible. Additional equipment should be connected to the system earth with the utmost care (see point 2.21). The relative wiring must not be fitted alongside the existing electronic circuits in order to avoid electromagnetic interference. The wiring of the electronic systems (length, conductor type, arrangement, clamping, connecting shield braids etc.) must follow the original IVECO standards. Carefully reset the original system after carrying out any work.

We recommend that electrical, electro-mechanical and electronic devices which comply with the following immunity requirements for electromagnetic emissions, both irradiated and conducted are used: The level of electromagnetic immunity of the electronic devices equipping the vehicle, at a distance of 1 metre from the transmitting aerial must be:

- 50V/m immunity for secondary devices, for frequencies ranging from 20 MHz to 1 GHz The maximum admissible variation in transient voltage for units powered with 24 V is ¦ 80V, as measured at the terminals of the artificial network (L.I.S.N.) during bench tests; otherwise, if the measurements are made on the vehicle, the variation must be determined at the most accessible point in the proximity of the device generating the disturbance. - 100V/m immunity for primary devices, for frequencies ranging from 20 MHz to 1 GHz. Operations on the electrical system Print 603.93.431 Base - July 2006 Revi - June 2007