Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-75 E URO C ARGO E URO 4 - 5 HAM and 2m radio system installation HAM (27 MHz) and 2m (144 MHz) radio systems must be installed using the power system provided in the vehicle. Connect to terminal 30 via a supplementary fuse. The systems must be legally type-approved and fixed (not portable). Install the transmitting part in a flat, dry area separate from the electronic components of the vehicle, away from humidity and vibrations. The antenna must be installed outside the vehicle, possibly on a large metallic base as vertically as possible with the connection wire leading downwards. Follow the instructions and the manufacturer’s warnings for assembly.

Selecting the right type of antenna and installing it correctly is crucial for ensuring maximum performance of the device. The antenna must be of good quality and it must be installed with care. Installation is very crucial as this determines the performance and, consequently, the range of the radio. The are two options concerning the type of installation: fixed (i.e. permanent) or on drip moulding (or other type of support). The second option is more practical and avoids the need to drill the vehicle body. Install at a distance which is no less than 1/2 lambda (wave length) from other antennas.

The middle of the roof is the best position because the mass plane is proportional in all directions. With assembly on a side or in any other part of the vehicle, the mass plane will be proportional to the mass itself. Follow the precautions below when connecting and arranging the wires: - Use a top-quality, low-loss coaxial antenna cable with the same impedance as the transmitter and the antenna. - The coaxial cable run must be at a suitable distance (minimum 50 mm) from pre-existing wiring (TV, radio, telephone, amplifiers and other electronic devices) to prevent interference and malfunctioning. Ensure the minimum distance from the metallic structure of the cab.

Cable installation on the left or right-hand side is preferable. - Clean the lower part of the hole made in the body for installing the antenna in fixed position so that the antenna support is perfectly connected to the vehicle earth. - The coaxial cable connecting the antenna to the radio must be fitted with the utmost care. Avoid curves or bends which can pinch or distort the cable. Avoid tangling. Shorten the wire as much as possible. Remember that any imperfections in the coaxial cable will cause severe interference for the radio transmitter. - Use existing holes for routing the cable.

Take all the necessary precautions for protecting the body if additional hole have to be drilled (use anti-rust paint, sheath, etc.). - Ensure a good connection with the vehicle earth both at the base of the antenna and at the device fixing to ensure maximum power transfer. Radio transmitters are typically fitted on the dashboard in the gear leverarea orin the header rail above the driver. If the equipment uses a 12v power supply, a suitable 24-12V DC/DC converter will have to be fitted (if not already provided). The power cables for the converter must be as short as possible with no coils and maintaining the minimum distance from the reference plane.

Operations on the electrical system Print 603.93.431 Base - July 2006 Revi - June 2007