Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-76 E URO C ARGO E URO 4 - 5 Notes for drip moulding fitting No special procedures are required for fitting vehicle antenna supports. Follow the instructions provided with the drip mould support. After assembly make sure there is a good earth connection between the vehicle and the metal support; check with the radio disconnected from the antenna cable. Check also that there is a good connection between the metal support and the body. It is important that the cable is suitably protected from deterioration regarding the drip moulding assembly and if the cable is routed between the door frame and the door.

IVECO recommends the fixed antenna installation is used in preference to the drip moulding type. Cellular telephone system installation Cellular telephone systems must be installed using the power system provided in the vehicle. Connect to terminal 30 via a supplementary fuse. The devices must be legally type-approved and fixed (not portable). Install the transmitting part in a flat, dry area separate from the electronic components of the vehicle, away from humidity and vibrations. The antenna must be installed outside the vehicle, possibly on a large metallic base as vertically as possible with the connection cable facing down.

Follow the instructions and the manufacturer’s warnings for assembly. The ideal location of the antenna is on the front of the cab roof at a distance no less than 30 cm from other antennas. Follow the precautions below when connecting and arranging the wires: - Use a top quality cable particularly as concerned to the protective shielding. - The cable route must be at a suitable distance (minimum 50 mm) from pre-existing wiring. Ensure the minimum distance from the metallic structure of the cab. Avoid excessively pulling or pinching the cable. Installation on the left or right-hand side is preferable. - Never shorten or extend the coaxial antenna cable.

- Use existing holes for routing the cable. Take all the necessary precautions for protecting the body if additional hole have to be drilled (use anti-rust paint, sheath, etc.). - Ensure a good connection with the vehicle earth both on the base of the antenna and at the device fixing to ensure maximum power transfer. Cellular telephones are typically fitted on the dashboard in gear lever area or in the header rail above the driver. If the equipment uses a 12v power supply, a suitable 24-12V DC/DC converter will have to be fitted (if not already provided).

The power cables for the converter must be as short as possible with no coils and maintaining the minimum distance from the reference plane. Operations on the electrical system Base - July 2006 Revi - June 2007 Print 603.93.431