Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-77 E URO C ARGO E URO 4 - 5 GPS antenna cable and navigation system installation Correct and careful assembly of GPS antennas in the vehicle is extremely important for correct operation and maximum performance. The antennas should if possible be fitted in a concealed position where they cannot be seen. Arranging the GPS antenna is a delicate matter. The power of the signal received from the satellite is very weak (approximately 136dBm), so any obstacle can effect quality and performance of the receiver. The GPS antenna must be installed in a position ensuring maximum visibility of the sky. The minimum angle of visibility must be 90 ° .

Sky visibility must not be obscured by objects or metallic structures. The installation position must be horizontal. The ideal location for the GPS antenna is under the plastic dashboard in the middle and at the base of the vehicle windscreen. Do not install the antenna under any type of metallic structure in the cab. Position the GPS antenna at a distance which is not less than 30 cm from another antenna. Follow the precautions below when connecting and arranging the wires: - Use a top quality cable particularly concerning the protective shielding. - The wire course must be at a suitable distance (minimum 50 mm) from pre-existing wiring.

Ensure the minimum distance from the metallic structure of the cab. Avoid excessively pulling or pinching the cable. Installation on the left or right-hand side is preferable. - Never shorted or extend the coaxial antenna cable. - Use existing holes for routing the cable. Take all the necessary precautions for protecting the body if additional holes have to be drilled (use anti-rust paint, sheath, etc.). - Ensure a good connection with the vehicle earth both on the base of the antenna and at the device fixing to ensure maximum power transfer. Navigation systems must be installed using the power system provided in the vehicle. Connect to terminal 30 via a supplementary fuse.

The devices must be legally type-approved and fixed (not portable). Install the transmitting part in a flat, dry area separate from the electronic components of the vehicle, away from humidity and vibrations. If the equipment uses a 12v power supply, a suitable 24-12V DC/DC converter will have to be fitted (if not already provided). The power cables for the converter must be as short as possible with no coils and maintaining the minimum distance from the reference plane. Operations on the electrical system Print 603.93.431 Base - July 2006 Revi - June 2007