Downloaded from https://www.everyspec.com MIL-HDBK-310 Because of the great geographic differences in the factors that influence its generation and disintegration in the atmosphere, the distribution of ozone exhibits considerable spatial and temporal variations. Ozone can be generated by natural processes in the troposphere and stratosphere and by chemical reactions between sunlight and pollutants in the troposphere. Most damage done to materiel would be expected to occur at or near the ground, because equipment must be in contact with high concentrations of ozone for hours or days before effects become serious.
In unpolluted air, concentrations tend to average less than 30 µ g/m 3 at sea level. However, where pollution is a factor, as it is in many urban areas, concentrations may exceed 200 µ g/m 3 5.1.20.1 Highest Recorded. In extremely severe pollution situations, such as in the Los Angeles basin, surface ozone concentrations as high as 1765 µ g/m 3 have been measured. A more likely extreme value in such areas is 980 µ g/m 3 . These high levels do not normally persist for more than a few days. 5.1.20.2 Frequency of Occurrence. Ozone concentrations for 1-, 5-, and 10-percent frequencies of occurrence are 220, 190, and 145 µ g/m 3 , respectively. 5.1.20.3 Long-term Extremes. Not available.
5.1.21 Sand and Dust. Sand and dust are terms used to designate small particles of matter, usually of mineral origin. A distinction is often made between sand and dust on the basis of size (dust particles are smaller), but there are no generally accepted specific size limits for the two kinds of particles. However, for most military applications it is important to distinguish between the smaller particles (dust) and the larger particles (sand) because of their primary effects on equipment. Airborne dust is primarily damaging because of its penetration and subsequent possible damage; whereas airborne sand is primarily damaging because of its erosion and abrasion effects on equipment.
Important characteristics are size, hardness, atmospheric concentrations, and to some extent, shape. Particles vary in diameter from 0.1 to 1,000 micrometers, but most airborne particles are less than 74 micrometers. Hardness also varies widely (from 1 to 9 on the Mohs scale) depending largely on mineral composition. Quartz, by far the most common mineral in larger particles, has a hardness of 7. Greatest particle concentrations are found near helicopters hovering over dry loose surfaces. Secondary concentrations are found near ground vehicles operating on unpaved surfaces, including many roads.
Lesser concentrations are associated with natural dust storms, although the areal extent of such storms may be substantial. Very few areas are exempt from sand and dust problems, at least during some part of the year. 5.1.21.1 Highest Recorded. Too few reliable and systematic measurements have been made to establish an extreme value. However, concentrations as high as 6.00 g/m 3 (particles smaller than 74 micrometers) have been measured inside the engine compartment of a tank moving over a very dusty surface. 24