Downloaded from https://www.everyspec.com MIL-HDBK-310 5.1.21.2 Frequency of Occurrence. Since this is not an observed climatic element, and is most often mechanically created, frequencies of occurrence are not applicable. Three concentration levels are provided; selection of the appropriate one depends on intended use of the materiel under consideration. Items likely to be used in close proximity to aircraft operating over unpaved surfaces should be designed for particle concentrations of about 2.19 g/m 3 in multidirectional strong winds (downwash from helicopter rotors). Such particles range in size up to 500 micrometers in diameter.
Items never in close proximity to operating aircraft, but which may be found near operating surface vehicles, should be designed for particle concentrations of 1.06 g/m 3 with wind speeds up to 18 mps at a height of 3 m. Particle sizes will range from less than 74 micrometers in diameter to 1000 micrometers, with the bulk of the particles ranging in size between 74 and 350 micrometers. These two categories are likely to include most military items. However, items that are assured of being subjected only to natural conditions should be designed for particle concentrations of .177 g/m 3 with wind speeds of 18 m/s at a height of 3 m.
Under these conditions, the bulk of the particle sizes are likely to be less than 150 micrometers except that some larger particles (up to 1000 micrometers) may be in motion within several feet above the ground. In all categories, temperatures are typically above 21 ° C (70 ° F) and relative humidities are less than 30%. For testing purposes, particle sizes up to 150 micrometers should be used if the primary concern is with the penetration of fine particles. If the abrasion effect of blowing sand is the primary concern, particle sizes up to 1000 micrometers should be used, but the bulk of the particles should be between 150 and 500 micrometers. 5.1.21.3 Long-term Extremes. Not available.
5.1.22 Freeze-Thaw cycles. A freeze-thaw cycle occurs at a specific site on any day that the temperature crosses the freezing mark. It is possible for more than one freeze-thaw cycle to occur at any site during a 24-hour period; however, because of the normal control of the daily temperature cycle by the solar cycle, this is not a common occurrence. Therefore, freeze-thaw cycles are described by the number of days in which they occur. Freeze-thaw is an important consideration in the design of many kinds of military equipment.
The effects on materiel are caused by alternate expansion and contraction of different materials and, especially, the change of state that water experiences during the freezing and thawing processes. These effects can exert great stress on susceptible components of materiel. For the above reason, freeze-thaw is of greatest potential concern as a factor affecting materiel in areas where abundant moisture is present immediately before or during the occurrence of the freeze-thaw cycle. The maximum number of freeze-thaw days in non-mountainous areas occurs in the mid-latitudes. The midlatitudes also have great variance in average number of freeze-thaw days.
In general, sites that have the most months with mean monthly temperatures at or near 0 ° C will have the greatest annual number of freeze-thaw days in nonmountainous areas. However, the greatest number of freeze-thaw cycles for the entire Earth occurs at high elevations in the tropics, where a freeze-thaw cycle may be an almost daily occurrence. For the purposes of this standard, high elevation sites in the tropics are considered anomalous locations and should not be used for the derivation of design criteria unless equipment is specifically intended for use in such areas. 5.1.22.1 Highest Recorded.
In tropical mountains at high elevations, freeze-thaw cycles 337 days annually and 31 days per month have been recorded. Elsewhere, a maximum of 31 days in one month also has been recorded. 25