Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 4.3.2.2 Validity. The formulas given in 4.3.3 are valid only when iron and other magnetic material are absent. 4.3.2.3 Accuracy. The formulas given in 4.3.3 are approximations based upon the assumption that each of the current loops is small enough to be replaced by its equivalent dipole. This means that the maximum distance between any two points on the largest loops is less than z/10 where z is the distance from the center of the array of loops to the horizontal plane on which it is desired to compute the vertical component of magnetic field.
Checks made for a number of cases indicate that the results given by the formulas for the maximum value of the vertical component on a plane at a distance z below the center of the array will be accurate, when the above conditions are satisfied to within a few percent. The percentage accuracy will be poor at points where the vertical component is nearly zero, but as we are primarily interested in the maximum values, this is of little importance. 4.3.2.4 Formulas for dipole arrays. The information provided with the formulas in 4.3.3 will include:
(a) A sketch showing the array of dipoles considered and a table listing the magnetic q oment and the rectangular coordinates on the center of each dipole in the array. In the sketch, each current loop is represented by a small arrow which gives the position and direction of the equivalent dipole. Formulas giving the components of magnetic field produced by the array of dipoles at a point with rectangular coordinates x, y, and z. By holding z constant and varying x and y, the vertical component can be computed at all points on a plane at a distance z below the center of the array. A similar procedure can be used to calculate the x and y components.
The values of x and y at the points where the vertical component of the magnetic field reaches its greatest magnitude on a plane at distance z below the center of the array. In many cases, the vertical component of magnetic field will have a number of maxima or minima (in the mathematical sense) of different magnitudes. The values given for x and y are for the points where the vertical component of magnetic field is greater than any of the others. A formula giving the maximum value of the vertical component of magnetic field on a plane at distance z below the center of the (b) (c) (d) array. 4.3.2.5 Contour maps of dipole arrays. 4.3.2.5.1 Two dipole arrays .
A contour map showing the vertical component of the magnetic field, in microtesla, on a plane 3 meters below the center of a specific array is provided for each array with only two dipoles (see 4.3.3.1 through 4.3.3.5). The microtesla values on the contour map are for dipole arrays with M = 2835 /un2, a - 0.3 m, and z = 3.0 m. 4.3.2.5.2 Arrays with more than two dipoles. A partial contour map showing the following is provided for each array with more than two dipoles: 38