Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 5.4 Principles of minimum magnetic moment and minimum separation. AS shown in the formulas given in 4.3, the magnetic field produced by two equal and opposite current loops or dipoles is proportional to the magnetic moment of each, times the distance between them. Therefore, the magnetic moments of individual current loops or dipoles must be as small as possible, and the loops muse be as close together as possible These are the principles of minimum magnetic moment and minimum separation. respectively.
Individually and together they point the way to a reduction in stray magnetic field, For example, suppose we have two equal and opposite dipoles a short distance apart. (a) If we halve the magnetic moment of each dipole and leave the separation unchanged, we halve the magnetic field. (b) If we halve the separation and leave the magnetic moments unchanged, we halve the magnetic field. (c) If we halve both the magnetic moment and the distance, the magnetic field is reduced to one fourth of its original value, 5.5 Principle of zero net magnetic moment. The arrays of dipoles considered in 4.3 show that the resultant or net magnetic moment for each array is zero.
This is the best overall condition for a small stray magnetic field from any number of dipoles. Expressed mathematically, the principle of zero net magnetic moment requires the following: where XMZ denote the sums of the x, y, and z components, respectively, of the magnetic moments of the current loops or dipoles under consideration. ~, Z?$., and 5.5.1 App1 ication to equipment. Consider a relatively large piece of equipment, for example, one that fills a cube 1.5 meters on a side. Suppose that there are large but equal and opposite current loops on two opposite faces of the cube.
The net magnetic moment is zero, but the stray magnetic field will be large because of the large magnetic moment of each loop and the large separation between the loops. Zero net q agnetic q oment alone is not enough to ensure a small stray magnetic field. The principle of zero net magnetic moment must be applied together with the principles of minimum moment and minimum separation. In other words , to ensure a small stray magnetic field for a piece of equipment we must meet the following conditions: (a) We must have zero net magnetic moment for the whole equipment (b) We must have zero net magnetic moment for each of a number of subgroups of loops.
The loops in each subgroup should be relatively close together and the combination of all the loops in all the subgroups represents all the loops in the equipment. For example, one subgroup might contain all the current loops in a single plane or in two parallel planes very close together; while another subgroup might include all the loops in a particular cubic meter of the equipment, and so forth.