147 Mains Interference 7.2 Harmonic Limitation Standards and Requirements The requirements for harmonic limitation can arise from: • Application-specifi c requirements • Requirements for compliance with standards The application-specifi c requirements are related to a specifi c installation where there are technical reasons for limiting the harmonics. Example: 250 kVA transformer with two 110 kW motors connected. Motor A is connected directly to mains supply, and Motor B is supplied through Frequency Converter B. There is a need to retrofi t FC A, so that Motor A is supplied through its own FC, but the transformer will, in this case, be undersized. Solution:
In order to retrofi t without changing the transformer, mitigate the harmonic distortion from FC’s A and B using harmonic fi lters. There are various harmonic mitigation standards, regulations and recommendations. Diff erent standards apply in diff erent geographical areas and industries. The most common are the following:
• IEC/EN 61000-3-2, Limits for harmonic current emissions (≤ 16A per phase) • IEC/EN 61000-3-12, Limits for harmonic currents (>16A and ≤75A) • IEC/EN 61000-3-4, Limitation of emission of harmonic currents (> 16A) • IEC/EN 61000-2-2 and IEC/EN 61000-2-4 Compatibility levels for low frequency conducted disturbances • IEEE519, IEEE recommended practices and requirements for harmonic control in electrical power systems • G5/4, Engineering recommendation, planning levels for harmonic voltage distortion and the connection of nonlinear equipment to transmission systems and distribution networks in the United Kingdom 7.3 Harmonic Reduction Methods in Frequency Converters The line current of unmitigated diode rectifi ers has a total harmonic distortion (THD) of at least 80%.
This high distortion value is unacceptable in most applications with FC’s. Therefore it is necessary to have some harmonic mitigation. The level of harmonic mitigation depends, as explained earlier, on the specifi c installation and the harmonic standards the installation needs to comply with.