156 Interfaces Integration of the FC into PC software gives the user full system confi guration and control. With PC Software it is possible to monitor the entire system more eff ectively for faster diagnosis, and better preventive maintenance. A modern PC Software tool can be used as follows: • For planning a new communication network offl ine. PC Software tools contain a complete database with supported FC products • For commissioning FC’s online • For easy replacement of a FC, in the event of failure • For easy expansion of the network with more FC’s • For back-up of parameter settings of FC’s in a communication network • Software supports fi eldbus protocol.
This will eliminate the need for an extra communication network Fieldbus Use a standardised fi eldbus interface between the PLC and FC for commissioning, control and monitoring of the application. Fig. 8.5 Fieldbus connection 8.2 Operating Principles of Serial Interfaces In serial data transmission, the bits (with a state of 0 or 1) are transmitted individually, sequentially. A logical 0 or a logical 1 is defi ned by specifi ed voltage levels. Various methods and standards have been developed to ensure fast, error-free data transfer. The method used depends on the specifi cation of the interface.
If we look at the lowest level of data transfer, a distinction can be made between how the bits are transmitted electrically (current or voltage signal) and the system used (line coding). If the bits are transmitted via a voltage signal, the focus is less on the voltage level than the reference potential of the level.