veda — Facts Manual

157 Interfaces Table 5.1 3 fi eldbus principles and typical specifi cations RS-232/ EIA-232 interface The RS-232 interface, launched as early as 1962, was for a long time the serial interface par excellence. When a serial interface was mentioned in relation to PCs, it referred to RS-232 RS-232 was conceived for communication between two devices (point-to-point connection) at low transmission speeds. RS-422/ EIA-422 interface RS-422 allows both point-to-point and multi-drop networks to be built. In multi- drop networks, it is possible to connect multiple receivers to one transmitter. The data is transmitted diff erentially via twisted data cables.

One pair of lines is needed for each transmission direction for full duplex operation. RS-485/ EIA-485 interface RS-485 is regarded as a higher-level version of the RS-422 standard and accordingly has similar electrical properties. In contrast to RS-422, however, RS-485 is designed as a multi-point (bus-capable) interface over which up to 32 devices can communicate. There are now also transceiver modules (combined transmitter and receiver module) with which networks of up to 256 devices can be implemented. The actual maximum possible network size depends on both the transmission rate (line length) and the structure of the network (network topology).

USB interface The Universal Serial Bus (USB) standard was developed in 1995 by Intel in conjunction Principle Standard (application) Devices connected per trunk circuit Max. distance in mm Number of lines Signal level RS 232 (point to point) 1 sender 1 receiver 15 Duplex min. 3+ various status signals ± 5 V min. ± 15 V max. RS422 (point to point) 1 sender 10 receivers 1200 Duplex: 4 ± 2 V min. RS485 (Bus) 32 senders 32 receivers 1200 Semi duplex: 2 ± 1.5 V min.