veda — Facts Manual

158 Interfaces with companies in the IT industry. The USB 2.0 extension of the standard in 2000 increased the transmission speed from 12 Mbps to 480 Mbps. Additionally, in 2008 USB 3.0 was introduced, allowing transmission speeds of up to 5 Gbitps. The data is transmitted diff erentially via a twisted pair. The maximum cable length between two devices must not exceed 5 m. Despite its name, USB is not a physical data bus, but rather a point-to-point interface. The term “bus” in the name USB refers only to the structure with which a network can be built. The USB specifi cation provides for a central host (master) to which up to 127 diff erent devices can be connected.

Only one device can be connected directly to a port. An additional hub is required to connect more than one device to a port. Ethernet interface The Ethernet standard was developed back in the early 1970’s. Since then Ethernet has become more and more present in all kinds of products. In the 90’s Ethernet found its way to the automation fi eld via protocols like: MAP, Modbus TCP and EtherNet/IP. Ethernet typically runs on 100 Mbps, over STP cables (Shielded Twisted Pair), but is also available in wireless, fi bre optic and other media.

The benefi t of using Ethernet is not only the fast speed and standardised cables & connectors, but the ability to access data inside automation equipment from the offi ce network. This allows status to be read from all over the plant, even from another continent. Despite the fact that all Ethernet protocols runs on Ethernet, it does not mean that it is possible to run diff erent Ethernet technologies in the same network. Technologies that change the arbitration or have strict demands towards timing make a mix of technologies impossible. The mainstream Ethernet technologies today are PROFINET, EtherNet/IP, Modbus TCP, POWERLINK and EtherCAT.

Today, these technologies have more than 90% of the market share in new installations. 8.3 Standard Serial Interfaces in Frequency Converters Today, most FC’s today are fi tted as standard with a serial system interface that can be used for connection to a network. Various standardised protocols are generally supported, in addition to unpublished, manufacturer-specifi c (proprietary) protocols. Physically, the interfaces are very often based on the specifi cation of the RS-485 interface.