164 Sizing ad Selection of Frequency Converters 9 Sizing and Selection of Frequency Converters 9.1 Get the Drive Rating Right Selecting the right Frequency Converter is a key aspect of designing a variable speed drive system. If the selected unit is too small, it will not be able to control the connected motor optimally at all necessary operating points. If, on the other hand it is too large, there is a risk that the motor will not always be controlled properly, and the design may not be cost-eff ective. For the design of most FC’s, knowledge of the following basic parameters is suffi cient:
• Rating of FC from motor specifi cations • Current distribution in the FC (cos φ of the motor) • Overload capacity • Control range and fi eld weakening • Derating of FC • Regenerative energy • Motor cable length • Environment • Central versus de-centralised installation After clarifi cation of the basic design parameters for an application, design and analysis of the mechanical components is carried out. The motor to be used must be determined before a suitable FC can be selected. In facility service systems, for example, fi nal selection often takes place only shortly before the building is completed.
Only at this time are most of the components to be used defi ned, so that an optimised analysis of fl ow conditions can be carried out reliably. The more dynamic and challenging the application, the greater the number of factors that must be taken into account in the design. Since FC manufacturers can save costs by restricting the technical features, for each particular case it is necessary to confi rm that the features needed for the drive are actually available.