veda — Facts Manual

176 Sizing ad Selection of Frequency Converters controllers and their associated motors is easy to see. In decentralised confi gurations, a fi eld-bus is usually used to control the drives. Fig. 9.10 Two concepts – diff erent sets of benefi ts When planning a decentralised installation, factors such as ambient temperatures, mains voltage drops, the limited motor cable lengths, etc. must be taken into account. Important factors such as these are often overlooked in the high-level design of engineering projects. For example, not only the decentralised units but also the supply cables must be suitable for the installation environment.

For instance the fi eld-bus cable must be suitable for a harsher environment and sometimes also of the fl exible type. In addition, installation of units in inaccessible locations should be avoided in order to ensure quick access for servicing. Another major consideration is the segmentation of a decentralised network. For economic reasons it is benefi cial to combine units into groups or segments. Careful consideration must be given to determining which segments require other segments for their operation, and which segments can, must, may, or should continue to operate autonomously.

For example, if certain chemical processes cannot be interrupted, the failure of a lower-level segment must not be allowed to disrupt important segments. Finally the expertise that is necessary for the installation of a decentralised network should not be underestimated. In addition to knowledge of the fi eld-bus systems used, the technician must be aware of the structure (what happens to the total system if an individual unit fails) and the ambient conditions of a decentralised network and must be able to estimate these eff ects. Although decentralised units are always more expensive than centralised units, well- conceived decentralisation concepts can achieve savings of around 25% compared