fujitsu RX2530 M4 — FUJITSU Server PRIMERGY RX2530 M4

Basic software procedures 5.2.1.2 Updating or recovering the iRMC iRMC flash procedure К Prepare a USB stick including the bootable iRMC firmware update image. К Connect the USB stick containing the iRMC firmware to a USB port. К Restart the server. The system will start the POST process. К During POST, press [F12] and select the connected USB stick as boot device. The system will detect the USB stick. К Choose one of the following options from the update tool menu to start the iRMC update process: Normal Choose this option to update an existing system board. Initial Choose this option if the system board has been replaced prior to the iRMC update procedure.

This option will perform all relevant flash procedures in a row, including the iRMC firmware and bootloader. V CAUTION! Do not interrupt the iRMC upgrade process after it has started. If the process is interrupted, the iRMC may be permanently corrupted. I If the iRMC does not work after flashing, disconnect the system from the mains and reconnect it again. К After completion of the flash process, remove the USB stick and restart the server. iRMC recovery procedure К Prepare a USB stick including the bootable iRMC firmware update image. К Ensure that the server has been shut down and disconnected from the mains, see section "Disconnecting the power cord" on page 50 .

К Connect the USB stick containing the iRMC firmware to a USB port. К Connect the server to the mains while pushing the ID button on the front panel. Ask a second person to help you if necessary. К Ensure that the Global Error indicator and the ID indicator are flashing to indicate that the server is entering the iRMC recovery state. К Press the Power On/Off button. The system will start the POST process. RX2530 M4 Upgrade and Maintenance Manual 83