Basic software procedures After replacing the front panel or Chassis ID EPROM К Check the SEL log files as described in section "Viewing and clearing the System Event Log (SEL)" on page 95 to verify whether a backup copy of the system board settings has been transferred to the Chassis ID EPROM: Chassis IDPROM: BMC FW backup successful 5.2.3 Updating expansion card firmware I For Japan: Follow the instructions provided separately. After replacing the expansion card, it is essential to upgrade the firmware to the latest version without connecting any storage devices. The latest expansion card firmware version is available from the Fujitsu support web pages at:
http://ts.fujitsu.com/support/ For Japan: http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/ I Note on the boot watchdog Before updating expansion card firmware, ensure that the boot watchdog is disabled, see section "Disabling the boot watchdog" on page 78 . After updating expansion card firmware, enable the boot watchdog again, see section "Enabling the boot watchdog" on page 92 . I Fujitsu does not assume responsibility for any damage done to the server or for the loss of any data resulting from firmware updates.
Using the ServerView Update Manager For more information on how to update the expansion card firmware using the ServerView Update Manager or Update Manager Express (UME), see the following manuals: ServerView Update Manager: "ServerView Update Management" user guide ServerView Update Manager Express: "Local System Update for PRIMERGY Servers" user guide RX2530 M4 Upgrade and Maintenance Manual 85